TubeFire 8™ 8 CHANNEL TUBE MIC-PREAMP SYSTEM USER’S GUIDE
HARDWARE OPERATION How to adjust the controls for the lowest noise Start with the GAIN and OUTPUT knobs centered, and the Pad switch IN. This provid
FIGURE 4 - Block Diagram 10
PC SOFTWARE OPERATION Installing the Windows PC driver (Check at www.artproaudio.com for any driver updates.) Run SETUP.EXE on the driver disk to in
Changing the sample rate STEP ONE: Open the ART Card Control panel on a PC, to modify the sample rate setting. FIGURE 6 - Control Panel Sample Rat
Changing the sample rate may lead to other issues, including audio dropouts. Monitor the ASIO Drop Outs for 10 - 20 seconds to assure that the num
Adjusting system latency with a Windows PC Adjusting the buffer depth varies the latency of the computer system used together with the TubeFire 8™.
Using the wordclock input with a Windows PC The TubeFire 8™ can be used in both simple and complex systems. The simplest system would consist of the
Mac SOFTWARE OPERATION Changing the sample rate with a Mac Run the AUDIO/MIDI setup utility to change the sample rate. Select properties for the devi
Using the wordclock input with a Mac The TubeFire 8™ can be used in both simple and complex systems. The simplest system would consist of the TubeFir
Creating an Aggregate Device with a Mac Control of multiple audio devices on a Mac is performed by creating a single Aggregate Device. What follows i
IMPORTANT SAFETY INSTRUCTIONS – READ FIRST This symbol, wherever it appears, This symbol, wherever it appears, alerts alerts you to the presence
APPLICATIONS Adding more TubeFire 8™ units to your system The TubeFire 8™ is designed to allow you to expand the number of inputs and outputs on you
Optionally rename the units in the ART Card Control Panel (Windows PC) or create an “Aggregate Device” (Mac) to simplify the ID of each unit. See the
WARRANTY INFORMATION Limited Warranty: Applied Research and Technology will provide warranty and service for this unit in accordance with the follo
SERVICE The following information is provided in the unlikely event that your unit requires service. 1) Be sure that the unit is the cause of the pr
TubeFire 8™ SPECIFICATIONS Input Impedance Mic...6.4K Ohm
NOTES 24
www.artproaudio.com E-mail: [email protected] © 2006 Applied Research & Technology 164-5004-201 25
The ART TubeFire 8 8 Channel Tube Mic-Pre System IMPORTANT SAFETY INSTRUCTIONS – READ FIRST ...1 INTROD
List of Figures FIGURE 1 - Input Channel ...
INTRODUCTION The TubeFire 8™ is the answer to your recording and computer interface needs. Eight high quality vacuum tube microphone preamps are pack
Firewire (IEEE 1394) (Sony iLINK®) Connections The TubeFire 8 has two 6 pin Firewire ports located on the rear panel. Both ports are identical, and c
Instrument Input The 1/4” TS jack on the front panel provides a high impedance unbalanced input, and when used, automatically switches off the mic pr
FIGURE 2 - Output Mix/Headphone section Headphone / Line Mixer All of the sources selected for the output jacks of the TubeFire 8™ are mixed togeth
REAR PANEL Balanced Input Jacks – XLR & 1/4” TRS Combo Jacks These balanced inputs are used for both microphone and line level signals. The gain
Commentaires sur ces manuels